WEEK 22: PRINTING 3D PRINTED BODY PARTS (3)

OBJECTIVE

1. To observe all the remaining 3D body parts.
2. To eliminate the supporting pillar and smoothing the remaining 3D body parts.
3. To collect all the 3D body parts.

METHODOLOGY

1. Go to the 3D printing service to observe the remaining 3D printing body parts.
2. Eliminate the supporting pillar using scrapper.
3. Smoothing the remaining 3D body parts using sand paper.
4. Collecting all the finishes 3D body parts.

RESULT

The figure below is the remaining 3D body parts that have been printed and smoothed. 

Some of the remaining 3D body parts have been clean using scrapper

ANALYSIS/DISCUSSION

All the 3D printing body parts have been smoothed and collected from sir Azman. The total of 3D printing service for my project is RM96.00 since the rate price introduce by sir Azman is according to the weight of the project which is 1g equal to RM1. My 3D body parts total weight is 96g. 

CONCLUSION

In conclusion, the 3D printing part for my project is done. All the body parts have been completely printed. Thus, now I can continue to develop my project.